DIY Guide: How to Easily Repair or Replace Your FERMAX 80447 Intercom Phone

DIY Guide: How to Easily Repair or Replace Your FERMAX 80447 Intercom Phone

The FERMAX 80447 intercom phone is a widely used and reliable unit in residential and commercial buildings. While it's known for its durability, like any electronic device, it may require occasional maintenance or replacement. The good news? Repairing or replacing the FERMAX 80447 is a simple task that you can do yourself with just a few basic tools.

Why Choose DIY Repair or Replacement?

  • Cost Savings: Hiring a technician can be expensive, but you can save money by handling it yourself.

  • Minimal Tools Required: You only need a screwdriver and basic wiring knowledge.

  • Quick and Easy Process: It takes less than 30 minutes in most cases.

  • No Special Skills Needed: If you can follow simple instructions, you can get it done.

Step-by-Step Guide to Replacing Your FERMAX 80447 Phone

Step 1: Gather Your Tools and Materials

Before you begin, ensure you have:

  • A Phillips-head screwdriver

  • A replacement FERMAX 80447 phone

  • A notepad or camera (to record wire positions before disconnecting)

Step 2: Remove the Old Intercom Phone

  1. Remove the handset from the base.

  2. Locate the first screw, which is typically found below the handset.

  3. Unscrew it to access the internal connections.

  4. Locate any additional screws securing the unit to the wall and loosen them.

  5. Gently pull the unit away from the wall to expose the wiring.

  6. Take a picture of the wire connections or label them for reference before unscrewing anything.

Step 3: Disconnect the Wires

  • The FERMAX 80447 has five terminals:

    • 1: Door strike

    • 2: Phone listening

    • 3: Common

    • 4: Ringtone

    • 6: Phone microphone

  • Unscrew the terminals and carefully remove the wires one by one.

Step 4: Connect the New Intercom Phone

  • Using your photo or notes as a guide, connect the wires to the corresponding terminals on the new unit.

  • Secure them properly to ensure a firm connection.

Step 5: Attach the New Unit to the Wall

  • Align the new intercom phone with the wall mount.

  • Secure it with the screws provided.

Step 6: Test the System

  • Test the new unit by making a call or buzzing the door.

Troubleshooting Common Issues

If your new FERMAX 80447 phone isn’t working after installation:

  • Check wire connections: Ensure all wires are properly secured in the correct terminals.

  • Verify power supply: Confirm that the system has power.

  • Test with another unit: If the issue persists, there may be a problem with the wiring in the building.

Conclusion

Replacing or repairing a FERMAX 80447 intercom phone is a straightforward process that requires minimal effort. With this DIY guide, you can avoid unnecessary service fees and have your intercom working perfectly in no time. If you need a replacement unit, be sure to choose a trusted supplier to guarantee quality and compatibility.

Need a new FERMAX 80447 phone or expert advice? Contact us at Maple Electronix, and we’ll be happy to help!

 

Back to blog